Create an ergonomic hanging wine rack with Dremel

Red wine is the most popular drink of the cold season. Tart and thick, it’s best to keep you warm on cold evenings. Dremel suggests making a versatile hanging wine rack for proper wine storage

.

Create an ergonomic hanging wine rack with the Dremel

What you’ll need:

– wooden slats

– 1 wooden bar

– Dremel Multitool 4000

– Sanding pad 430 6.4mm, grit 60

– wood cutting blade SC544

– multipurpose drill bit 561

– universal cutting kit 565

– Dremel Glue Gun 930

– screwdriver

– screws

– dowels

– self-tapping screws

– metal chain.

Step 1

To make the composite parts of the shelf, saw a wooden bar into several pieces. The back and front of the shelf should be 50x2cm and the sides should be 25x2cm. Use the Dremel Multitool 4000 with Wood-Cutting Blade SC544 . Sand the edges of the pieces with your Dremel 4000 and the Dremel sanding mandrel 430 , 6.4mm, 60 grit.

Step 2

Take the wood strips and cut them into 12 even pieces you’ll need 2 racks for each bottle . Each piece of wood must be no shorter than 22 cm in length. Use your Dremel 4000 with wood cutting blade SC544 to make these coasters.

Step 3

Take the front and back of the two strips of wood for the wine rack and mark on them where the laths will be located. Place pencil marks along the entire length of the made front of the shelf – you’ll need them to cut kerfs for the bottles. To make it easier to fit the bottles into the shelf, cut a half circle to accommodate the containers. To get the job done, use the Dremel 4000 and the Universal Cutting Kit 565 . Finish off the edges of the half slices with your Dremel Multitool 4000 with Dremel 6.4 mm sanding mandrel, grit 60 430 .

Step Four

Secure the laths at the designated points using the Dremel Glue Gun 930 . Now you just need to screw all the parts together to complete the shelf. Make holes in the shelf components and put the metal angle brackets in them. Then screw in the 25mm screws and tighten them with the screwdriver. To make the wine rack even more comfortable, you can add a rack to hang your glasses from it. All you need to do now is screw the metal rack on the underside of the shelf with a screwdriver.

Step 5

Screw the self-tapping screws into the corners of the front of the wine shelf. Attach a metal chain to them – this will allow you to put the shelf anywhere in your kitchen.

Step 6

Now all that’s left is picking a good spot to hang the craft from. To fix the wine cabinet, measure the distance between the self-tapping screws. Fit four holes in the ceiling with your Dremel 4000 and the multipurpose drill 561 and then put in the dowel pin and put in four more self-tapping screws. Hang the shelf.