Personal Mantel? Quick, easy and original!

It’s easy and simple to create an upbeat atmosphere at your indoor or outdoor party. You can make a quick and easy personal mantel for this.

Personalized fireplace

So, to create a personal fireplace you will need:

– The Dremel 4000 multitool

– Comfort Guard 550

– A shallow metal bucket

– Wire mesh

– Gel Fuel

– Stones

Step 1.

Make a mark on the wire mesh. It should match the diameter of the bucket which will be the base of the new fireplace . To make it quick, simply flip the bucket over, place it on the mesh and trace around with a pencil.

Step 2.

Cut a circle out of the metal wire mesh. Do not forget to wear gloves – metal can spark while working. To deflect sparks, use Comfort Guard 550. To install the attachment, remove the Dremel 4000 handpiece and replace it with the Comfort Guard 550. The clear shield rotates around the tip, adjust it as needed to better reflect the sparks. When cutting metal set the rotational speed to a low RPM, increasing it slowly if necessary. For example, you need to increase the speed if the metal workpiece vibrates.

Step 3.

Put the gel fuel in the bucket. Then place the cut off part of the net in the bottom of the bucket. The wire mesh should be no more than 2.5cm high. Finish your composition with a layer of pretty stones.

Congratulations, your fireplace is ready! Now you just need to call your friends and light a fire.